Bus Conversion Magazine Bulletin Board

Bus Discussion => Bus Topics ( click here for quick start! ) => Topic started by: zubzub on February 06, 2010, 03:46:29 PM



Title: Any one have anything good or bad to say about this impact gun. SK-92141
Post by: zubzub on February 06, 2010, 03:46:29 PM
It's a 3/4" impact with 1200 ft/lbs of torque. 
http://www.skhandtool.com/Default.aspx?fusemode=10&pid=92141 (http://www.skhandtool.com/Default.aspx?fusemode=10&pid=92141)
Guy is selling it cheap ($150) a little worn but will do for me unless it has some kind of weakness I haven't been able to find online.  Basically I have a 1/2" with about 450 ft/lbs but need something a lot stronger for soem of the hard to reach palces and my 1" impact is a monster and basically a mistake at this point I will sell it once I get a decent 3/4".  So any info helpful.


Title: Re: Any one have anything good or bad to say about this impact gun. SK-92141
Post by: Just Dallas on February 06, 2010, 04:45:17 PM
Removed


Title: Re: Any one have anything good or bad to say about this impact gun. SK-92141
Post by: busnut104 on February 06, 2010, 05:30:15 PM
I bought a I/R on e-bay I believe the # is 231 but not sure around 1200lb tork, around 100.00 bucks nice shape,  do not be in a hurry and watch e-bay.


Title: Re: Any one have anything good or bad to say about this impact gun. SK-92141
Post by: zubzub on February 07, 2010, 07:09:17 PM
Looking for the big 1200 ft/lbs so 3/4"it is. No one have this gun? I figure it's probably good, I can handle the weight, would be surprised if my 1/2" weighed less.


Title: Re: Any one have anything good or bad to say about this impact gun. SK-92141
Post by: wrench on February 08, 2010, 04:53:47 AM
It's a 3/4" impact with 1200 ft/lbs of torque. 
http://www.skhandtool.com/Default.aspx?fusemode=10&pid=92141 ([url]http://http://www.skhandtool.com/Default.aspx?fusemode=10&pid=92141[/url])
Guy is selling it cheap ($150) a little worn but will do for me unless it has some kind of weakness I haven't been able to find online.  Basically I have a 1/2" with about 450 ft/lbs but need something a lot stronger for soem of the hard to reach palces and my 1" impact is a monster and basically a mistake at this point I will sell it once I get a decent 3/4".  So any info helpful.


 I would go for it, if anything not up to par, there is nothing complicated in there(2 bearing, a drum, 4 fiber vanes, 1 hammer,1 anvil). & SK you can have parts anytime.
            wrench