Bus Conversions dot Com Bulletin Board
December 20, 2014, 09:22:44 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: This BB is intended for the sole purpose of sharing conversion and bus related information among visitors to our web site. These rules must be followed in order for us to continue this free exchange of info. No bad mouthing of any business or individual is permitted. Absolutely no items for sale are to be posted, except in the Spare Tire board. Interested in placing a classified or web ad, please contact our advertising dept. at 714-903-1784 or e-mail to: info@busconversions.com.

   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: starter problems?  (Read 922 times)
Texasjack
Newbie
*
Offline Offline

Posts: 41




Ignore
« on: July 04, 2006, 06:43:45 AM »

My model 10 eagle has a new starter and batteries, it starts every time when cold but if I drive 20 miles and stop the motor and try to restart it will hardly crank.Is it my starter or batteries? thanks
Logged
Sammy
Hero Member
*****
Offline Offline

Posts: 523




Ignore
« Reply #1 on: July 04, 2006, 07:02:06 AM »

Disconnect the batterys.

Clean & inspect ALL the battery cables - to starter, to junction block,even the ones on the back of the shut off switches, then secure them.
Don't forget the ground cables too, even from engine block to chassis.

I would then check the voltage drop on each cable, one at a time.
If you get more than .3volts while cranking, I would replace it.

Is the starter motor "rebuilt", "remanufactured" or "new" ?
It is possible that the starter motor could be defective, you would have to check the current draw on it while cranking.

Good luck with your repair.
Sammy  Cool


Logged
ROGER DOLAN 4106
Newbie
*
Offline Offline

Posts: 2




Ignore
« Reply #2 on: July 06, 2006, 05:27:48 PM »

   Almost all   hard starting proplems can be traced to a bad connection in the start system some where . On older buses its a good idea to strip back some insulation on the cable and see if there is some greencroshion showing. Won't carry full amperage
. Time to replace.



                                                        Roger 
                                                               
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!