Bus Conversions dot Com Bulletin Board
April 20, 2014, 02:15:07 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an E-Mag Subscription:  It will not get lost in the mail.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: 102a3 Voltage Regulator @nd question  (Read 729 times)
fairlang
Newbie
*
Offline Offline

Posts: 6





Ignore
« on: July 10, 2006, 08:26:08 AM »

Thanks to Nick and Stan for reply on first post.  In the 3rd bay is where I have all my utilities and may have to remove my tanks to get to the regulator. Stan, the only cover that I remember is the one covering the air tank. Is this the one that you are referring to ?When I look at the rear bulkhead from the outside, in front of the drive wheels, I cannot see where the regulator may be.  Thanks for any and all help.
Logged
Beatenbo
Sr. Member
****
Offline Offline

Posts: 275


1993 MCI 102 C3 Cat Power


WWW

Ignore
« Reply #1 on: July 10, 2006, 10:35:56 AM »

Should be at top in corner where the tunnel holds all your air lines and cables. Normally it is a cover that is hinged with vent holes. My fresh water tanks is in last right bay and I fixed so I could drain and remove if I need to get to voltage regulator. Good Luck, Charlie
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!