Bus Conversions dot Com Bulletin Board
December 20, 2014, 09:50:06 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: It will not get torn up or crushed if you back over it with your bus.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: Wheel Bearing Adjusting Tool  (Read 747 times)
JackConrad
Orange Blossom Special II
Global Moderator
Hero Member
*****
Offline Offline

Posts: 4447


73' MC-8 8V71/HT740 Southwest Florida


WWW
« on: May 20, 2009, 02:37:43 PM »

   I have received several emails asking about the dimensions of the wheel bearing adjusting toll that I made. I answered the emails, but decided to put the photo with dimensions on here for anyone else that is interested. This tool was made to fit an MC-8. I do not what other makes or models it will fit. For the 2 1/4" pins I used cut off 60 penny spikes.  Jack
Logged

Growing Older Is Mandatory, Growing Up Is Optional
Arcadia, Florida, When we are home
http://s682.photobucket.com/albums/vv186/OBS-JC/
bobofthenorth
Hero Member
*****
Offline Offline

Posts: 2107



WWW

Ignore
« Reply #1 on: May 20, 2009, 04:24:00 PM »

When I was replacing a rear seal in my buddy's shop last week he had one of these.  Worked slicker than goose $#!% and beat manhandling that big dirty drum 14 ways from Sunday.
Logged

R.J.(Bob) Evans
1981 Prevost 8-92, 10 spd
My website
Our weblog
Simply growing older is not the same as living.
HighTechRedneck
Global Moderator
Hero Member
*****
Offline Offline

Posts: 2939


BCM Editor


WWW
« Reply #2 on: May 21, 2009, 08:25:53 AM »

It is a very handy little tool. I am going to use it to adjust the curbside front bearing on my RTS.  I seem to have a little too much play in it.
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!