Bus Conversions dot Com Bulletin Board
October 25, 2014, 08:27:40 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: You will not have to go out in the rain, sleet, hail, or snow to retrieve it.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: Wheel Bearing Adjusting Tool  (Read 733 times)
JackConrad
Orange Blossom Special II
Global Moderator
Hero Member
*****
Offline Offline

Posts: 4447


73' MC-8 8V71/HT740 Southwest Florida


WWW
« on: May 20, 2009, 02:37:43 PM »

   I have received several emails asking about the dimensions of the wheel bearing adjusting toll that I made. I answered the emails, but decided to put the photo with dimensions on here for anyone else that is interested. This tool was made to fit an MC-8. I do not what other makes or models it will fit. For the 2 1/4" pins I used cut off 60 penny spikes.  Jack
Logged

Growing Older Is Mandatory, Growing Up Is Optional
Arcadia, Florida, When we are home
http://s682.photobucket.com/albums/vv186/OBS-JC/
bobofthenorth
Hero Member
*****
Offline Offline

Posts: 2092



WWW

Ignore
« Reply #1 on: May 20, 2009, 04:24:00 PM »

When I was replacing a rear seal in my buddy's shop last week he had one of these.  Worked slicker than goose $#!% and beat manhandling that big dirty drum 14 ways from Sunday.
Logged

R.J.(Bob) Evans
1981 Prevost 8-92, 10 spd
My website
Our weblog
Simply growing older is not the same as living.
HighTechRedneck
Global Moderator
Hero Member
*****
Offline Offline

Posts: 2935


BCM Editor


WWW
« Reply #2 on: May 21, 2009, 08:25:53 AM »

It is a very handy little tool. I am going to use it to adjust the curbside front bearing on my RTS.  I seem to have a little too much play in it.
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!