Bus Conversions dot Com Bulletin Board
March 31, 2015, 05:00:15 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: You will not have to go out in the rain, sleet, hail, or snow to retrieve it.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: the 1990 Orion  (Read 657 times)
wrench
Full Member
***
Offline Offline

Posts: 166





Ignore
« on: June 13, 2009, 07:11:40 AM »

 Sorry to post a new post, but...
Ok,  engine running square but last only 30-45 second & sut down, there must be a sensor who call safety.
 How do I trace that? any way to read codes?
   thank         wrench       waiting
Logged
MCI-RICK
Full Member
***
Offline Offline

Posts: 149


1986 TMC 102A3 6V92TA




Ignore
« Reply #1 on: June 13, 2009, 07:20:42 AM »

Wrench,

Did any indicator lights turn on?  Your SEL (stop engine light) or CEL (check engine light)?  Is there a toggle switch by the DDEC connector?  If there is, you hold it towards the side that says DDEC.  Your CEL indicator will start blinking.  Count the blinks.  A 45 for example will blink 4 times then a short pause then blink 5 times.   

MCI-Rick
Logged

Aim high but look out below
wrench
Full Member
***
Offline Offline

Posts: 166





Ignore
« Reply #2 on: June 13, 2009, 08:43:26 AM »

  THANKSSSS RICK,
 I add water & it stay running, about that plug, is it located in the engine bay or at the driver station?(I saw a plug under the dash left of steering collum, like the one on GM car & truck).
      thanks again    wrench
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!