Bus Conversions dot Com Bulletin Board
September 18, 2014, 06:50:18 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an E-Mag Subscription: You will not have to go out in the rain, sleet, hail, or snow to retrieve it.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: 102a3 Voltage Regulator @nd question  (Read 787 times)
fairlang
Newbie
*
Offline Offline

Posts: 6





Ignore
« on: July 10, 2006, 08:26:08 AM »

Thanks to Nick and Stan for reply on first post.  In the 3rd bay is where I have all my utilities and may have to remove my tanks to get to the regulator. Stan, the only cover that I remember is the one covering the air tank. Is this the one that you are referring to ?When I look at the rear bulkhead from the outside, in front of the drive wheels, I cannot see where the regulator may be.  Thanks for any and all help.
Logged
Beatenbo
Sr. Member
****
Offline Offline

Posts: 275


1993 MCI 102 C3 Cat Power


WWW

Ignore
« Reply #1 on: July 10, 2006, 10:35:56 AM »

Should be at top in corner where the tunnel holds all your air lines and cables. Normally it is a cover that is hinged with vent holes. My fresh water tanks is in last right bay and I fixed so I could drain and remove if I need to get to voltage regulator. Good Luck, Charlie
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!