Bus Conversion Magazine Bulletin Board
May 25, 2018, 05:45:09 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: New ownership began September 1st 2012!  Please send any comments to info@busconversions.com
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: Drive shaft yoke nut 4905  (Read 1182 times)
Offline Offline

Posts: 47

« on: August 08, 2009, 09:29:17 AM »

Does the drive shaft yoke nut tightness on the the transmission of a 4905 w/ standard trans establish bearing preload Huh I have a little - (1/16") up and down play on the yoke. The seal is not leaking. Could someone please tell me what the torque value of that nut is Huh Thanks, Bill.
Hero Member
Offline Offline

Posts: 551

« Reply #1 on: August 08, 2009, 10:55:55 AM »

End yoke nut 500-550 FT.-Lbs per 4905 M/M section 17 page 27.
jlv Tongue
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!