Bus Conversion Magazine Bulletin Board
October 18, 2017, 11:35:28 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: It will not be stolen by your mailman or your neighbor who also may be into buses.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: Governed RPM setting for a 8V92T  (Read 783 times)
Doug1968
Full Member
***
Offline Offline

Posts: 153





Ignore
« on: August 27, 2009, 07:59:20 PM »

Fellows,

What should the governed RPM setting be for my 86 8V92T?

How does one go about adjusting this setting?

Doug
Logged

1986 MCI 102A3 - 8V92 - 5 speed
Vancouver, Washington
luvrbus
Hero Member
*****
Online Online

Posts: 18373




Ignore
« Reply #1 on: August 27, 2009, 08:07:08 PM »

Doug, mine is set at 2250 rpm no load the factory setting is 1900 or 2100 rpm I'll send you a email on how do it.
If you don't have a good electronic hand held no contact tack gun don't do it with the dash tack because they are not that accurate.
Anyway you can post a photo of the back of the governor housing so I can tell if you have a tamper proof one or not
Another way you can tell  on the left side on the back of the housing there is a cylinder looking thing about 4 inches long check and see if you can feel 2 bolt heads if so no problem but if you feel 1 bolt it may be a problem if the plug is still in it
good luck
« Last Edit: August 27, 2009, 09:18:53 PM by luvrbus » Logged

Life is short drink the good wine first
TomC
Hero Member
*****
Offline Offline

Posts: 8417





Ignore
« Reply #2 on: August 27, 2009, 09:11:01 PM »

2250rpm would be my choice as the highest no load setting for a 92 series.  92's do not like high rpm-compared to a 71 series that can be turned up to 2600rpm without problem (my 8V-71 is at 2400rpm).  Good Luck, TomC
Logged

Tom & Donna Christman. '77 AMGeneral 10240B; 8V-71TATAIC V730.
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!