Bus Conversion Magazine Bulletin Board
June 18, 2018, 02:18:41 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: New ownership began September 1st 2012!  Please send any comments to info@busconversions.com
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: some rough pics of 4104 spring brake install.  (Read 1073 times)
Hero Member
Offline Offline

Posts: 1212

'53 4104. Roadworthy but rough around the edges.


« on: November 12, 2009, 06:08:03 PM »

I find it hard to remember  get under the bus with a camera when I am in the middle of a job, so i only have "after" pics.  This is the spring brake install I did. The two relays...
....if I were to do it again I would get a relay that did both functions, cleaner install as it's a little tight in there.
springbrake can near the firewall.

There were maybe 2" to spare but....the captive bolts just make it in when the springs are pushing.
and finally a picture of part of the dreaded all aluminum suspension arm


Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!