Bus Conversions dot Com Bulletin Board
July 31, 2015, 06:07:42 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: You will not have to go out in the rain, sleet, hail, or snow to retrieve it.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: 3/4 in through the water pump...  (Read 783 times)
Danny
Sr. Member
****
Offline Offline

Posts: 268


87' MCI 102A3 - getting there...


WWW

Ignore
« on: July 30, 2006, 10:22:50 PM »

Question-  I am wanting my supply lines (pex) to be 1/2 in.  However, I have read where one should use 3/4 in to the manifold and then 1/2 from there.  My question is, are most pumps set up to handle 3/4 tubbing on this end or 1/2 inch?

Thanks,
Danny
Logged

I have heard it said, "life comes at you fast".  I didn't know it would be in the shape of a bus  :-)
Nick Badame Refrig/ACC
1989, MCI 102C3, 8V92T, HT740, 06' conversion FMCA# F-27317-S "Wife- 1969 Italian/German Style"
Global Moderator
Hero Member
*****
Offline Offline

Posts: 4922


Nick & Michelle Badame


WWW
« Reply #1 on: July 31, 2006, 03:04:17 AM »

Hi Danny,

Most newer pumps are setup as 1/2" in and out. If you can pipe 3/4" to the inlet, you will decrease the work of the pump. [kinda like sucking through a straw

the bigger the straw the easier it is to draw it up] Than you will have maxium preasure at the 1/2" supply!

Good Luck
Nick-
Logged

Whatever it takes!-GITIT DONE! 
Commercial Refrigeration- Ice machines- Heating & Air/ Atlantic Custom Coach Inc.
Master Mason- Cannon Lodge #104
https://www.facebook.com/atlanticcustomcoach
www.atlanticcustomcoach.com
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!