Bus Conversions dot Com Bulletin Board
October 21, 2014, 11:35:43 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: This BB is intended for the sole purpose of sharing conversion and bus related information among visitors to our web site. These rules must be followed in order for us to continue this free exchange of info. No bad mouthing of any business or individual is permitted. Absolutely no items for sale are to be posted, except in the Spare Tire board. Interested in placing a classified or web ad, please contact our advertising dept. at 714-903-1784 or e-mail to: info@busconversions.com.

   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: Universal joint bolt threads stripped  (Read 571 times)
scotty_vince
Newbie
*
Offline Offline

Posts: 37





Ignore
« on: June 05, 2010, 04:16:18 PM »

After I bought my bus (4104) the guy I bought it from told me that a while back the ujoint had broke and the drive shaft came off one end (not sure if it's drive or axle side). He said that he was able to fix it but when he put it back together a few of the bolt holes were stripped enough that he wasn't able to tighten them completley. He said that I could retap it or shoot a helicoil in the holes that are stripped. The bus runs and drives fine but I havnt driven it much and when I did I took it real easy. My question is basically has anyone else dealt with this situation? Any info would be m ???uch appreciated.
Logged
oldmansax
Tom & Phyllis
Hero Member
*****
Offline Offline

Posts: 999


'82 Bluebird Wanderlodge PT40




Ignore
« Reply #1 on: June 05, 2010, 04:30:46 PM »

I would never use helicoils on a U-joint, myself. I have drilled out the threads & used an appropriate sized bolt, nut, & lock washer.

TOM
Logged

'82 BlueBird WanderLodge PT40 being rebuilt
Delaware

DON'T STEAL! The government hates competition!
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!