Bus Conversions dot Com Bulletin Board
October 31, 2014, 01:55:37 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: It takes up much less space in your bus.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: Stumped on a couple wires.  (Read 881 times)
Wax-um
Newbie
*
Offline Offline

Posts: 47


1982 MCI Conversion project


WWW

Ignore
« on: July 10, 2010, 12:12:37 PM »

I removed the side stainless duct work from the plywood interior floor on my 82 MCI 9. Their are a couple wires that go through the plywood front section of the floor that I cant figure out what they are for. Anyone know. I dont want to cut any wires until Im 100% confident what they are for.
Logged
gumpy
Some Assembly Required
Hero Member
*****
Offline Offline

Posts: 3274


Slightly modified 1982 MC9


WWW

Ignore
« Reply #1 on: July 10, 2010, 12:41:38 PM »

Maybe the aisle and seat lights?


Post some photos.

Also, the wires should be marked with circuit numbers.  Post those, too.
Logged

Craig Shepard
Located in Minnesquito

http://bus.gumpydog.com - "Some Assembly Required"
mikelutestanski
Sr. Member
****
Offline Offline

Posts: 381


Mikes Metal Mistress




Ignore
« Reply #2 on: July 10, 2010, 02:24:55 PM »

Hello;    more info needed for an acccurate answer.  A guess could be the 2 wires that go to the heat sensor that regulates the heater valve . The sensor is located in the return air duct and the wires end up in the front J box..   just a guess...
With the wire colors and gage you could possibly get info from the wiring diagram. 
  Regards  mike
Logged

Mike Lutestanski   Dunnellon Florida
  1972 MCI 7
  L10 Cummins  B400R  4.625R
gumpy
Some Assembly Required
Hero Member
*****
Offline Offline

Posts: 3274


Slightly modified 1982 MC9


WWW

Ignore
« Reply #3 on: July 10, 2010, 06:21:46 PM »

Hello;    more info needed for an acccurate answer.  A guess could be the 2 wires that go to the heat sensor that regulates the heater valve . The sensor is located in the return air duct and the wires end up in the front J box..   just a guess...
With the wire colors and gage you could possibly get info from the wiring diagram. 
  Regards  mike

That sensor is wired into the A/C j-box in the front bay.

Logged

Craig Shepard
Located in Minnesquito

http://bus.gumpydog.com - "Some Assembly Required"
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!