Bus Conversion Magazine Bulletin Board
April 29, 2016, 01:00:30 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: New ownership began September 1st 2012!  Please send any comments to info@busconversions.com
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: wheel seal ???  (Read 629 times)
Sr. Member
Offline Offline

Posts: 490

« on: August 03, 2010, 09:34:26 AM »

I have replaced wheel bearings and wheel seal, how far should the test drive be before I would feel comforatble that this thing isn't going to leak. I messed up filling oil, I filled through the power divider plug which over filled it. On my first test run it pushed oil out the vent. I went home drained oil to the proper level , then took it on another 40 mile test run and all is dry. Is this far enough to feel comfortable that I didn't blow the seal??


Have Fun!!
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!