Bus Conversions dot Com Bulletin Board
December 20, 2014, 02:55:17 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: You can zoom in to make the text larger and easier to read.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: 8V92 HEAD BOLTS  (Read 983 times)
luvrbus
Guest

« on: September 07, 2006, 04:40:40 PM »

can somebody please tell me what the torque in ft lbs for a 8v92 head my book tells me a 100lbs then turn the bolt 90 degrees this sucks ,Sammy if you read this thanks for the part number i see why you call it peanut butter
Logged
Dallas
Guest

« Reply #1 on: September 07, 2006, 04:52:38 PM »

My 1980 vintage book has 250-260 lb-ft or 339-352 Nm
Logged
luvrbus
Guest

« Reply #2 on: September 07, 2006, 05:05:54 PM »

thanks Dallas i did it at 250 lbs and the bolt was at 90 degrees from where it was at a 100 lbs thanks again
Logged
Burgermeister
Guest

« Reply #3 on: September 08, 2006, 01:06:17 AM »

The 90 deg after reaching 100 lbs torque isn't a "sucky" term,  Manufacturers give a torque figure in order to impose a certain amount of stretch to the bolt in order to prevent loosening in service.

90 degrees, depending on the overall length of the bolt may have been the correct amount of stretch.

As it appears you found out!

Onward and Upward

Marc Bourget
Logged
Happycampersrus
Full Member
***
Offline Offline

Posts: 120




Ignore
« Reply #4 on: September 08, 2006, 04:45:38 AM »

Luvrbus


Did you use NEW bolts???

Dale
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!