Bus Conversion Magazine Bulletin Board
January 20, 2017, 10:24:09 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: This BB is intended for the sole purpose of sharing conversion and bus related information among visitors to our web site. These rules must be followed in order for us to continue this free exchange of info. No bad mouthing of any business or individual is permitted. Absolutely no items for sale are to be posted, except in the Spare Tire board. Interested in placing a classified or web ad, please contact our advertising dept. at (657) 221-0432 or e-mail to: info@busconversions.com.

   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: Replacing wheel bearings, and a question!  (Read 1362 times)
Example is more powerful than reproach. ~Aesop
Hero Member
Offline Offline

Posts: 506


« on: September 15, 2006, 02:43:45 AM »

I've been rebuilding the front suspension on the bus, I started with wheel bearings on the passenger side, it has taken me about 2 weeks to disassemble, blast, and paint, then replace bearings and seal! Now the question when i took the bearing cap off, the nut that holds and tightens the wheel bearing was locked in place with a washer that bends up to lock it in place, the nut was not tight, or I should say it was as i expected it to be on a regular car or truck.  When I started working on the drivers side wheel, the same nut took a pipe wrench to loosen!  Big difference between both sides. Now there is a large threaded washer that holds the correct pressure on the bearings, all the nut that I'm taking about serves as a locking device......just how tight should the outer lock nut be?......................As always thanks!           Pat


1982 Prevost LeMirage

Full Member
Offline Offline

Posts: 217

« Reply #1 on: September 15, 2006, 04:07:10 AM »

The outer locking nut, I tighten fairly tight to a place where I can bend the locking washer over the flat on the nut. All this nut is doing is holding the lock in place to hold the inter nut.
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!