Bus Conversions dot Com Bulletin Board
July 23, 2014, 05:03:30 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an E-Mag Subscription: By clicking on any ad, a hotlink takes you directly to the advertiserís website.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: power awning  (Read 720 times)
robertglines1
steam nut
Hero Member
*****
Offline Offline

Posts: 3969





Ignore
« on: April 02, 2011, 08:39:05 AM »

A&E power awning with the scissor type arms. Motor turning shaft turning;roll not turning    Shaft turning inside roll. Is there a shear pin  or clutch inside roller? where? before I tear into it.    Bob
Logged

Bob@Judy  98 XLE prevost with 3 slides --Home done---last one! SW INdiana
luvrbus
Hero Member
*****
Online Online

Posts: 12055




Ignore
« Reply #1 on: April 02, 2011, 10:18:27 AM »

Bob, feel for a indention on the roller you should find rivets there they shear, at least they do a Zip/Dee


good luck
Logged

Live each day like it was your last,one day it will be
robertglines1
steam nut
Hero Member
*****
Offline Offline

Posts: 3969





Ignore
« Reply #2 on: April 02, 2011, 10:35:01 AM »

will ck it out and post results
Logged

Bob@Judy  98 XLE prevost with 3 slides --Home done---last one! SW INdiana
robertglines1
steam nut
Hero Member
*****
Offline Offline

Posts: 3969





Ignore
« Reply #3 on: April 02, 2011, 11:57:45 AM »

got it end cap had flat place to act as locking mech was rounded out
Logged

Bob@Judy  98 XLE prevost with 3 slides --Home done---last one! SW INdiana
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!