Bus Conversion Magazine Bulletin Board
May 31, 2016, 03:18:41 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: You will not have to go out in the rain, sleet, hail, or snow to retrieve it.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: 1 [2]  All   Go Down
Author Topic: turbo and injector size question  (Read 2425 times)
Just Dallas
Bus Conversion Stuff on a Budget
Hero Member
Offline Offline

Posts: 846


« Reply #15 on: July 10, 2011, 06:59:10 PM »

Don, why not try something simple.
GMC's used a single wide mudflap behind the rear axle that almost touched the ground. This effectively created a low pressure area at the bottom of the engine compartment which drew the hot air down and out the bottom.

Oh, and just a thought, if you happen to have across the rear bumper... remove it, you'll see a decrease in heat retention in the engine compartment.

Just a couple of Dinar's worth.


I'm just an old chunk of coal... but I'm gonna be a diamond someday.
Pages: 1 [2]  All   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!