Bus Conversions dot Com Bulletin Board
December 18, 2014, 08:20:17 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: New ownership began September 1st 2012!  Please send any comments to info@busconversions.com
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: blower alignment tool??  (Read 402 times)
thomasinnv
Derrick Thomas
Hero Member
*****
Offline Offline

Posts: 751


I may be nuts, but only for buses


WWW

Ignore
« on: July 10, 2011, 10:19:37 AM »

my DD service manual says to use an alignment tool when re-installing the blower to the engine block, i assume for proper alignment of the drive shaft. is this tool a must have or can the job be done without it? could the same thing be accomplished just by using the drive shaft?

Clifford, had time to get to the P.O. yet? let me know what i owe ya.
Logged

There are three kinds of people in this world....those that make things happen, those that watch things happen, and those that just wonder what the heck is happening. Which one are you?

1977 MCI Crusader MC-8
8V71N/740
95% converted (they're never really done, are they?)
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!