Bus Conversion Magazine Bulletin Board
May 26, 2018, 03:26:13 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: It will not turn yellow, get musty, dusty, and mildewed or fade.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: what is behind rear cargo bay  (Read 1466 times)
Glenn & Sharon
Offline Offline

Posts: 16

mci 9

« on: October 19, 2006, 03:33:28 PM »

we are making the bus run on wvo need to run lines to engine . and bring coolant line to the second bay. and wires for the valves in the engine compartment to driver control panel

wvo is waste veggie oil 
Hero Member
Offline Offline

Posts: 1942

« Reply #1 on: October 19, 2006, 06:44:13 PM »

On the MCI pictured in your avatar, if I read your question correctly, ony the drive axle, air tank, air valves, and suspension components are directly behind most of the wall. The upper outer inner panel goes into the wheel well/inner fender area, and the center tunnel is an opening to the engine room. You could perhaps run all of your plumbing thru the tunnel, or use the heater circuits?
You may find a small tunnel in the upper street side rear bay wall. Some MC9s had an air starter supply line running through a 4"X4" (or thereabouts) tunnel. Exits just next to the upper inside corner of the rear junction box.


JR Lynch , Charlotte, NC
87 MC9, 6V92TA DDEC, HT748R ATEC

"Every government interference in the economy consists of giving an unearned benefit, extorted by force, to some men at the expense of others.

Ayn Rand
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!