Bus Conversions dot Com Bulletin Board
December 21, 2014, 02:10:25 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription:  It will not get lost in the mail.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: What is this lever do? No pic, description only  (Read 561 times)
Paladin
Dave Knight
Hero Member
*****
Offline Offline

Posts: 711





Ignore
« on: November 08, 2011, 07:13:17 PM »

I'm too lazy to look it up and know that someone must know already.

In my MC-8, inside the right rear door where the air compressor used to be located, forward of the door and just above I think. There is a grey lever mounted along the outside (right) wall.  Bear with me, with my back I was unable to spend much time in there getting a good view or to trace it but it looks like air lines in and out of it.....does this sound familiar to anyone?

If not I guess I could try to climb in there again and get a photo.
Logged

'75 MC-8   'Event Horizon'
8V71  HT740
Salt Lake City, Utah

"Have bus will travel read the card of the man, a Knight without armor in a savage land...."
challenger440
Full Member
***
Offline Offline

Posts: 189


WWW

Ignore
« Reply #1 on: November 08, 2011, 07:18:54 PM »

Not really sure, but on my mc7 thats about where the tag axle valves would be.  On the seven, there are little doors on the outside of the coach, where the valves are located,  to dump tag presure when needed.

John M.
Logged

John M.
Helena, Mt
MC7  "under construction"
buswarrior
Hero Member
*****
Offline Offline

Posts: 3571


'75 MC8 8V71 HT740




Ignore
« Reply #2 on: November 08, 2011, 07:20:03 PM »

tag valves was my idea too.

happy coaching!
buswarrior
Logged

Frozen North, Greater Toronto Area
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!