Bus Conversions dot Com Bulletin Board
November 29, 2015, 07:44:27 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: New ownership began September 1st 2012!  Please send any comments to info@busconversions.com
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: frame rubber bumper over suspension mc1  (Read 907 times)
Full Member
Offline Offline

Posts: 164

« on: October 19, 2006, 07:34:16 AM »

Over the years I have read posts talking about the bolts being stuck holding the frame rubber bumpers over the front & rear suspension. Almost every post talked about the bolt being frozen & the need to drill out etc. What I have found on my mci-8 on all four rubber bumpers is that they are tack welded in two places on the large washer to the frame. I have my bus blocked up off the ground and the rearend and the front suspension removed. After cutting away the damaged rubber two perfect tach welds per bumper.I cut the welds with a cutoff wheel and the bolts unscrewed from the frame with minium effort. Just info. Has anyone else discovered this. Thanks Ray
Tom Y
Hero Member
Offline Offline

Posts: 934

80 5C With Cummins L10 in Progress

« Reply #1 on: October 20, 2006, 06:59:26 PM »

Rayshound, Mine had no weld on them.  2 of the 4 broke off.    Tom Y

Tom Yaegle
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!