Bus Conversion Magazine Bulletin Board
March 17, 2018, 09:46:13 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: You will not incur forwarding fees when you are on the road.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: Flight102C-3 AC ? original  (Read 652 times)
steam nut
Hero Member
Offline Offline

Posts: 4361

« on: February 01, 2012, 03:38:29 PM »

On the coach I just re did the roof openings were as Clifford said 14 by 14 the air box for ducted air below them was approx 5 inches tall  24 inches square and divided in the middle for cold air return and distribution box for ac distribution which were 3 inch flex plastic hose stating and terminated in galvanized sheet metal {round duct) with plastic  diffusers on end.There were also approx 2 inch by 12 inch rectangular ducts fro distribution but require ceiling height reduction... If your roof isn't raised this will cause problems with height.     The XLE these measurements came from is a tall coach with a 84 inch inside height.  Hope this information helps you.   Bob ##### note every time you bend air it restricts flow and takes more power to move side benefit it quietens down noise.
« Last Edit: February 01, 2012, 07:16:40 PM by robertglines1 » Logged

Bob@Judy  98 XLE prevost with 3 slides --Home done---last one! SW INdiana
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!