Bus Conversions dot Com Bulletin Board
September 30, 2014, 11:07:52 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an E-Mag Subscription: It takes up much less space in your bus.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: Norgren relay/valves  (Read 359 times)
robertglines1
steam nut
Hero Member
*****
Offline Offline

Posts: 4013





Ignore
« on: April 13, 2012, 01:46:40 PM »

To those of you with tag lift using norgren relay/valves. Just wanted to say before you lay out 180$ for a new one .  take it apart it is very simple spool system with o rings. There is one that is 3/16th wide on most of the spools that is a little more pricey than the rest at  45 cents. Total parts cost to rebuild. $1 or less. I use lithum grease when reassembling. The o rings get brittle after years and start to leak or break and really leak or send false signals.  Just thought I would mention this while it is fresh in my thoughts.     Bob
Logged

Bob@Judy  98 XLE prevost with 3 slides --Home done---last one! SW INdiana
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!