Bus Conversion Magazine Bulletin Board
February 22, 2017, 07:30:25 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: You will not have to go out in the rain, sleet, hail, or snow to retrieve it.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: turn signal gasket  (Read 571 times)
Full Member
Offline Offline

Posts: 135

« on: May 31, 2012, 10:47:48 AM »

I have a couple of turnsignal/marker lights that are in quite nice shape, but the rubber gasket is gone. Bluebird no longer stocks it, they want to replace whole assy at over $90 a pop.  The old gasket is a u shaped deal that goes around  the socket assy and is the seal for both the assy and the lens. It's made by a German company R & S. I've not hand any luck with any searches.   Anyone have any suggestions on how to make or find something suitable? I've included some pics including numbers stamped on back and a detail of the gasket.  Thanks in advance.

1991 Bluebird AARE
1995 Land Rover Discovery
Hero Member
Online Online

Posts: 17366

« Reply #1 on: May 31, 2012, 11:00:06 AM »

Buy the foam gasket tape and make those not really hard to do

Life is short drink the good wine first
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!