Bus Conversion Magazine Bulletin Board
February 22, 2018, 08:59:47 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: You will not have to go out in the rain, sleet, hail, or snow to retrieve it.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: 1 [2]  All   Go Down
Author Topic: Starter Button Stopped Working  (Read 3904 times)
Paso One
Hero Member
Offline Offline

Posts: 574

« Reply #15 on: January 16, 2013, 01:59:29 PM »

Another idea is installing a push button neutral safety switch.

I installed one so I could start the old VH 9 in gear, this allowed the transmission to warm up faster on our - 40 mornings.

Actually one of the factory upgrades for the VH-9 caused engagement grinding unless transmission was warm.

Worked well I might leave it wired up as it is just a jumper between two terminals in the front panel.  short piece of wire and a spring loaded button.

Your just pushing two buttons to start.  Theft device also Smiley

68 5303 Fishbowl 40' x 102" 6V92 V730  PS, Air shift  4:10
1996 MCI 102 D3
Hero Member
Offline Offline

Posts: 3620

« Reply #16 on: January 16, 2013, 02:08:25 PM »

The old semi I used to drive had two start buttons (Cadillac) and had to be held down until the oil pressure came up.

Ash Flat, AR
Pages: 1 [2]  All   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!