I looked up the part number for the switches that replace what's already in the bus like the factory ones, and they were $50-$75 each. EXPENSIVE SWITCHES! I was able to use one of the switches from another spot that wasn't being used anymore, and I swapped them out. I installed some halogen lights to the back of the bus for reverse lights, I ran those to one of those switches. You are saying I should use a cube relay for those correct? I noticed that there was a whole volt lost on the wire when I turned the switch on. Do you think that is due to it running thru the small switch?
Also, I had to jump the bus off tonight because I left the battery on to long while working with the lights. How many volts does it take to start the bus? I had 11.6 volts when I measured it with a voltage reader right on the battery. Thanks!