Bus Conversion Magazine Bulletin Board
June 21, 2018, 07:38:20 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: It will not get torn up or crushed if you back over it with your bus.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: 1 2 [All]   Go Down
  Print  
Author Topic: Docking lights  (Read 5242 times)
lostagain
Hero Member
*****
Offline Offline

Posts: 2490


MC5C




Ignore
« on: June 09, 2014, 06:54:21 AM »

Often recently, I have had to back up in the dark when pulling in somewhere at night. I would like some lighting on the side of the bus so I can see what's there so I don't swing into things. What is available in recessed docking lights? Another option is work lights that could be bolted to the side of the bus. Or attached to the mirrors. Although I don't really want the bus to start looking like a dump truck. LED would be best. I have looked on a few lighting sites, but haven't found much.

JC
Logged

JC
Blackie AB
1977 MC5C, 6V92/HT740
luvrbus
Hero Member
*****
Online Online

Posts: 19413




Ignore
« Reply #1 on: June 09, 2014, 07:19:33 AM »

Build your own JC have Matt (saddleup) send a photo of the ones I made for his bus you don't want the plastic stuff on a good looking 5 like yours. I had the housing made of S/S on a angle and recessed behind the siding and used 3x5 lights with a S/S bezel County Coach like it so much they started doing on their bus conversions  
 
good luck
« Last Edit: June 09, 2014, 08:46:15 AM by luvrbus » Logged

Life is short drink the good wine first
sparkplug188
Sr. Member
****
Offline Offline

Posts: 251


1979 Model 5 Eagle - 45/102 8v92 HT740




Ignore
« Reply #2 on: June 09, 2014, 07:48:53 AM »

I have seen several motorhomes with three or four RV porch lights mounted along the roof line on each side.  The advantage of having the lights higher up is that taller obstructions like trees and power lines will be lit instead only seeing the bottom two feet of obstructions.

You can get either white or amber lenses.  There are quite a few LED bulb options that vary from nightlight to spotlight.



Another option is sealed automotive fog lights mounted both on the roof and under the bays.  You can buy fog lights as small as 1.5" round.  They accomplish the same thing as the porch lights, but can be mounted much higher up and out of the line of sight of people standing near the bus.
« Last Edit: June 09, 2014, 07:52:18 AM by sparkplug188 » Logged
Cary and Don
Hero Member
*****
Offline Offline

Posts: 799




Ignore
« Reply #3 on: June 09, 2014, 08:22:23 AM »

Our Eagle has recessed lights on the front and rear bay doors.  They light up like day when on. They also are great for getting around the bus when parked at night.

Don and Cary
Logged

1973 05 Eagle
Neoplan AN340
Taibob
Jr. Member
**
Offline Offline

Posts: 58




Ignore
« Reply #4 on: June 09, 2014, 08:27:21 AM »

 
JC,
I have two ,new in box, some day to install, down on the list,
A round tu-it type job.

Optronics Inc.
Porch/docking lights
Model 691
part # 69100101
Bulb # 30000112
12vdc

These are white plastic, 8 x 9 in. units, with 5x5 in. ss backer for light.
Light is 4 in. round.
My friend Al, installed them in his mci 5 and they looked good.

Bob
Logged

84 mci 9  8v71n N70 Jakes 740 auto 2 Slides    BC/AB Canada
chessie4905
Hero Member
*****
Offline Offline

Posts: 2714





Ignore
« Reply #5 on: June 09, 2014, 09:52:27 AM »

   Here's another choice, although have no personal experience with then. They look nice and compact. How about an infared back up camera instead? No lights needed with them.   

http://www.imarineusa.com/innovativelightingdockinghullback-uplights-white.aspx

Logged

GMC h8h 649#028 (4905)
Pennsylvania-central
Audiomaker
Full Member
***
Offline Offline

Posts: 156





Ignore
« Reply #6 on: June 09, 2014, 10:23:06 AM »

Just go on ebay.  I already ordered mine since I had the exact same idea.

Search for "docking lights"

You can get flush mount that should direct the lights into the appropriate area if you want a sleek installation.

Here's what I got...

http://www.ebay.com/itm/AQUA-SIGNAL-85101-1-WHITE-OVAL-PLASTIC-BOAT-DOCKING-LIGHTS-PAIR-/190902000268?pt=Boat_Parts_Accessories_Gear&hash=item2c72a55a8c&vxp=mtr

I've had a lot more boats than RV's and I wouldn't be surprised if I put as much marine stuff in my rig as RV stuff.

Cheers!
Logged
luvrbus
Hero Member
*****
Online Online

Posts: 19413




Ignore
« Reply #7 on: June 09, 2014, 11:01:24 AM »

Those things with mounting frames look tacky on a bus with siding sticking out over the siding JMO
Logged

Life is short drink the good wine first
TomC
Hero Member
*****
Online Online

Posts: 8640





Ignore
« Reply #8 on: June 09, 2014, 11:50:46 AM »

Go to this site-they have all sorts of exterior rated bright LED's. I've ordered from them and are prompt with delivery. http://www.superbrightleds.com/ Good Luck, TomC
Logged

Tom & Donna Christman. '77 AMGeneral 10240B; 8V-71TATAIC V730.
sparkplug188
Sr. Member
****
Offline Offline

Posts: 251


1979 Model 5 Eagle - 45/102 8v92 HT740




Ignore
« Reply #9 on: June 09, 2014, 12:07:40 PM »

luvrbus or saddleup - I would really like to see some pictures of what you built.

Another thought--  You could mount fog lights inside the radiator air intake grilles on each side.  The light could be mounted completely out of sight.  I will post a diagram of what I am thinking below:

 

Edit: You could even mount lights up inside the wheel wells with some sort of expanded metal housing to protect the lights from rocks.
« Last Edit: June 09, 2014, 12:12:00 PM by sparkplug188 » Logged
robertglines1
steam nut
Hero Member
*****
Offline Offline

Posts: 4365





Ignore
« Reply #10 on: June 09, 2014, 02:33:24 PM »

I have the stock docking cornering lights from Prevost (came with shell) I agree with Clifford If it were not having the holes to deal with they would be changed. That said one is located it the lower entrance door . 1  driver side below ticket window close to bottom in front of steer wheel.   1 each in front of the drive axle L & R  A switch on the dash turn all on or you can control with your turn signals for cornering. I do like location and function.   Bob
Logged

Bob@Judy  98 XLE prevost with 3 slides --Home done---last one! SW INdiana
Charles in SC
Sr. Member
****
Offline Offline

Posts: 397




Ignore
« Reply #11 on: June 09, 2014, 07:05:41 PM »

I always wanted to mount an old timey police car spot light on the drivers corner.
Logged

S8M 5303 built in 1969, converted in 2000
Midwilshire
Full Member
***
Offline Offline

Posts: 171





Ignore
« Reply #12 on: June 10, 2014, 08:13:51 PM »

luvrbus or saddleup - I would really like to see some pictures of what you built.

I'll second that. 

Been looking to do this for a while now, but haven't found anything classy enough that I feel good cutting a hole in the side of the bus.
Logged

Michael & Gigi
1978 MCI-5C "Silverliner"
Full-timers in the DC area
luvrbus
Hero Member
*****
Online Online

Posts: 19413




Ignore
« Reply #13 on: June 10, 2014, 08:23:31 PM »

Matt will be along this board is just to damn hard for me to post photos now FB is a cake walk for me
Logged

Life is short drink the good wine first
saddleup
Sr. Member
****
Offline Offline

Posts: 426





Ignore
« Reply #14 on: June 11, 2014, 06:13:16 AM »

now that the suns up...on a side note how the hell i retreve my password to get in the E=mag...tryied every password i ever had..
top pic driverside front....and a rear driver side

and yes this bus needs a washin and a polishin...
« Last Edit: June 11, 2014, 06:17:32 AM by saddleup » Logged

Yuma,Az


1974 Eagle 05 On the road, to Somewhere
John316
Hero Member
*****
Offline Offline

Posts: 3547

MCI 1995 DL3, DD S60, Allison B500.




Ignore
« Reply #15 on: June 11, 2014, 06:50:46 AM »

Here is what we used. They are bright, and we have several of them. http://www.amazon.com/Attwood-Docking-Light-Stainless-Steel/dp/B001O0DEH6/ref=sr_1_3?ie=UTF8&qid=1402496459&sr=8-3&keywords=docking+light
Logged

Sold - MCI 1995 DL3. DD S60 with a Allison B500.
eagle19952
Hero Member
*****
Offline Offline

Posts: 3709




Ignore
« Reply #16 on: June 11, 2014, 10:19:25 AM »

Build your own JC have Matt (saddleup) send a photo of the ones I made for his bus you don't want the plastic stuff on a good looking 5 like yours. I had the housing made of S/S on a angle and recessed behind the siding and used 3x5 lights with a S/S bezel County Coach like it so much they started doing on their bus conversions  
 
good luck

Here's the picture of what Clifford built:
Logged

Donald PH
1978 Model 05 Eagle w/Torsilastic Suspension,8V71 N, DD, Allison on 24.5's 12kw Kubota.
scanzel
Hero Member
*****
Offline Offline

Posts: 844





Ignore
« Reply #17 on: June 12, 2014, 05:01:46 AM »

Great looking Attwood docking lites but at almost $250 a pair !!!
Logged

Steve Canzellarini
Berlin, CT
1989 Prevost XL
Dave5Cs
Hero Member
*****
Offline Offline

Posts: 3297


1979 MCI MC5Cs 6V-71 644MT Allison, Roseville, CA




Ignore
« Reply #18 on: June 12, 2014, 06:10:13 AM »

That was what I was thinking. The price of these things, they should change my tires also!... There is a light and a light holder Bezel. Maybe some wire? You probably have to provide your own wire eh!... where is all the money in these.

Dave
Logged

"PATHFINDER"(Bus)
Toed 1998 Jeep TJ
Pages: 1 2 [All]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!