Bus Conversions dot Com Bulletin Board
October 07, 2015, 01:10:48 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: It will not be stolen by your mailman or your neighbor who also may be into buses.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: 8V92 fuel fitting  (Read 447 times)
Sr. Member
Offline Offline

Posts: 280

1973 MCI MC-7 Combo


« on: July 14, 2014, 04:59:25 PM »

You may remember my post a while back about my fuel leak.....I had a 1/4" brass nipple as the fuel inlet fitting on the driver side head on my 8V92.  The brass nipple cracked in half and was leaking fuel down onto my exhaust manifold.  I was very lucky that it did not break off completely.  In that thread, Clifford said that the correct fuel fitting was a long hex nipple and he thought it was made by Parker.  I searched on the web for this and had no luck and replaced it with a regular steel nipple.  I always respect Cliffords opinion cause he has probably forgotten more than I will ever know about these engines so I kept looking for the right fitting and I found an old Parker catalog that had them as a part number 4-4 MHLN-4.  I took this to my buddies at the local NAPA store and they found a place that carries Parker and they crossed it to a new number 1/4X4.0 FFF-S and I managed to get one!  Since my engine is still apart while I replace all the coolant hoses, I decided to go back and change the fitting to the correct one.  You could argue that a standard steel nipple is plenty strong enough in this application and your right but I enjoyed the challenge of finding the right one!  Its also easier to put in and take out since it is a 4" long full hex fitting.

I attached some photos.

Bruce & Nancy Fagley
1973 MCI MC-7 Combo Freighter
450HP DD 8V-92T 2000 Reman
HT 740 Allison
Woodbury CT.
Hero Member
Offline Offline

Posts: 529

'60 PD4104-4355(sold) Now Freightliner Conversion

« Reply #1 on: July 14, 2014, 05:04:14 PM »

Persistence pays!  Good job!


Gary D

USBUSIN was our 1960 PD4104 for 16 years Ustruckin' is our 2001 Freightliner truck conversion
Hero Member
Offline Offline

Posts: 14691

« Reply #2 on: July 14, 2014, 05:07:24 PM »

There you go Bruce that one won't break  Roll Eyes

Life is short drink the good wine first
Hero Member
Offline Offline

Posts: 5263

1980 MCI MC-5C

« Reply #3 on: July 14, 2014, 05:18:36 PM »

I'm gonna check tomorrow and see if that's what I have!  good job!


1980 MCI MC-5C, 8V-71T from a M-110 self propelled howitzer
Spicer 8844 4 speed Zen meditation device
Tatamagouche, Nova Scotia
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!