Bus Conversions dot Com Bulletin Board
November 27, 2015, 03:32:18 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: It will not get torn up or crushed if you back over it with your bus.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: 4106 SHEPPARD POWER STEERING CONCERN  (Read 447 times)
Jr. Member
Offline Offline

Posts: 63

« on: July 30, 2014, 08:08:10 PM »

I have a concern about our Sheppard power steering unit.  The bushing and a seal appear to have slid down the shaft out of the cast iron body.  I am attempting to attach a photo. Wish me luck!  Does anyone know if I am missing a part between the body and the pitman arm?  Is there something that holds the bushing and seal in place?  Any help would be appreciated!
Hero Member
Offline Offline

Posts: 3617

« Reply #1 on: July 31, 2014, 09:31:41 PM »

That looks familiar, I think mine did this. The nut on the end of the shaft wouldn't tighten and the steering wheel would take a small jump when I tried to turn it.

It appears the nut has fallen off yours, but it has been a while and I'm guessing.

Ash Flat, AR
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!