Bus Conversions dot Com Bulletin Board
August 21, 2014, 03:00:02 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an E-Mag Subscription: It will not get torn up or crushed if you back over it with your bus.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: wheel studs  (Read 1359 times)
martyinga
Newbie
*
Offline Offline

Posts: 3




Ignore
« on: April 25, 2006, 05:54:45 PM »

I am installing aluminum wheels on an MC8. I have determined that the wheel studs wil have to be  changed. Any tips or tricks will be greatly apreciated Thank you
Logged
gumpy
Some Assembly Required
Hero Member
*****
Offline Offline

Posts: 3202


Slightly modified 1982 MC9


WWW

Ignore
« Reply #1 on: April 25, 2006, 07:25:13 PM »

Take a look at the mechanical section on my web site (bus.gumpydog.com). Find the site map and the mechanical section. Under that, you'll find steer, drive and tag axle maintenance. One or more of these have some info on how I changed mine, including some things I did incorrectly. It's ok if you learn from my mistakes.

Use a length of pipe to press the studs into the hub. Don't pound on the end of the stud, or draw them in with the backing nuts (I did both, one worked, one didn't, but neither were correct). The pipe worked best.

Getting the old ones out is easy if the hub is off the bus. Good time to check the bearings, change the seals and wipers and do any brake or suspension maintenance.

craig

Logged

Craig Shepard
Located in Minnesquito

http://bus.gumpydog.com - "Some Assembly Required"
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!