Bus Conversions dot Com Bulletin Board
August 29, 2014, 11:16:42 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If your computer is lost, damaged, or stolen, we will replace all of your E-Mags for free.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: 4905 Engine Pull Question  (Read 1228 times)
Rick Brown
Jr. Member
**
Offline Offline

Posts: 61




Ignore
« on: April 25, 2006, 06:37:47 PM »

I'm in the process of pulling the 8v71 out of my 4905.  The book says "Loosen dust cap from transmission propeller shaft slip joint".
When I look into the goo I don't see any obvious dust cap.  At what point does the transmission separate from the axle?  Does one u-joint go with the trans & the other stay with the axle or does the yoke pull out of the transmission?
Thanks for any input.
-Rick Brown in Reno, NV
Logged
Geoff
Hero Member
*****
Offline Offline

Posts: 518





Ignore
« Reply #1 on: April 25, 2006, 07:38:18 PM »

Right where the driveline separates (slip joint) there is a cap with a seal that screws into the larger half of the driveline.  Rather than letting the driveline separate you could take the driveline entirely off at each u-joint, this would make putting it back on easier.

--Geoff
Logged

Geoff
'82 RTS AZ
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!