Bus Conversion Magazine Bulletin Board
March 19, 2018, 05:50:45 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: The dog will not eat it.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: 4108 Bay Door Adjustment  (Read 255 times)
Hero Member
Offline Offline

Posts: 638

« on: November 14, 2017, 12:32:03 PM »

One of our bay doors is not closing just right - the top right corner is a bit away from the body of the bus when the door is closed. It's not a major thing, but there is a slight (1/8") gap between the door and the gasket going down from the top right corner for just a little bit. The top right also seems to be a little lower than the left.

The manual seems to indicate that to adjust I should move the lower pivot down, enlarging the holes in the mounting bracket if necessary.

Anyone attempted such an adjustment? Any advice on getting the top right of the door pulled in a bit?

1974 GMC P8M4108a-125 (Current Bus)
1964 GM PD4106-2412
Located in beautiful Wisconsin
Hero Member
Offline Offline

Posts: 2333

« Reply #1 on: November 14, 2017, 02:50:06 PM »

Look carefully that the plywood ceiling isn't bowed or warped from water damage in the past. Also, make sure one of the rubbers isn't starting to part.

GMC h8h 649#028 (4905)
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!