Bus Conversions dot Com Bulletin Board
July 30, 2014, 08:18:56 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an E-Mag Subscription: You will not have to go out in the rain, sleet, hail, or snow to retrieve it.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: Leaving the driver's heat...  (Read 1063 times)
Danny
Sr. Member
****
Offline Offline

Posts: 268


87' MCI 102A3 - getting there...


WWW

Ignore
« on: May 10, 2006, 10:58:33 AM »

I am wanting to leave the driver's heat but remove the bus heat.  What are some things to keep in mind when doing this?

Thanks...!

Danny
Logged

I have heard it said, "life comes at you fast".  I didn't know it would be in the shape of a bus  :-)
TomC
Hero Member
*****
Offline Offline

Posts: 6682





Ignore
« Reply #1 on: May 11, 2006, 10:43:48 PM »

What I did was to move the big heater core inside with 2-14" radiator fans to power it.  Now I have a gigantic heater but without the underneath being blocked.  If you don't want to do that, then just splice the radiator coolant lines so they run to the front, install a ball valve so you can truly turn it off in summer, and put a toggle on the dash to run the electric booster pump for the heater.  I haven't had to use the electric booster pump yet-the engine water pump seems to do a good job.  Good Luck, TomC
Logged

Tom & Donna Christman. '77 AMGeneral 10240B; 8V-71TATAIC V730.
Gary W
Full Member
***
Offline Offline

Posts: 125



WWW

Ignore
« Reply #2 on: May 12, 2006, 09:10:05 AM »

Danny

I just removed the large heater core from the bus heating and kept the fans in as I kept the bus air. The drivers heat and defroster works great.

Gary
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!