Bus Conversions dot Com Bulletin Board
September 23, 2014, 07:27:46 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an E-Mag Subscription: It will not get torn up or crushed if you back over it with your bus.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
  Print  
Author Topic: cummins big cam 6-allison 740 into mc9  (Read 1560 times)
jimg1955
Newbie
*
Offline Offline

Posts: 5




Ignore
« on: May 15, 2006, 06:54:19 PM »

what years did mci run short output shaft allison740,i was told  mci built some cummins powered mc9s mated to short shaft allison.converting my 9 from 6v92 to cummins.need flywheel flex plate,short housing,  shaft,and short bellhousing.any help would be appreciated. thanks -jim
Logged
TomC
Hero Member
*****
Offline Offline

Posts: 6791





Ignore
« Reply #1 on: May 16, 2006, 07:51:06 AM »

If you already have the NTC motor, then you're dialed into the project.  And that will be the only mechanical engine that Cummins makes with enough power for the bus (L10 was a bit lacking).  But- If I can make a suggestion- the Big cam is exactly that- BIG and heavy.  Actually about 200lb heavier than the Series 60.  If I were doing the conversion, I'd look for an M11 or ISM with either the HT740 or HD4060 (World) transmission.  I can assure you that there are hundreds of these setups around since this is the engine of choice for most of the trash trucks.   The ISM weighs at least 650lb less, is no taller than the 6V-92TA (don't have to modify the floor under the bed), and is not as long as the NTC.  In this day and age of politically correctness, having a bus that doesn't smoke is very important-getting worse as time goes on.  It is very difficult to makes an NTC not smoke-that's why the electronic N14 was brought out.  This so bad that I'm going to put a smoke turbo on my 8V-71N so my engine doesn't smoke at altitude (also want to go to Colorado and be able to climb the hills).  If you want to go completely modern and have an engine that weighs in about 1,200lb less than the NTC, the most recent version of the ISL has common rail fuel injection that makes it almost as quiet as a gas engine (sort of weird how quiet it is) and in RV version puts out 400hp with 1,200lb/ft of torque-more than enough power.  Always many different ways to go for power.  Good Luck, TomC
Logged

Tom & Donna Christman. '77 AMGeneral 10240B; 8V-71TATAIC V730.
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!