Bus Conversion Magazine Bulletin Board
February 25, 2018, 08:04:38 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: It can be read on any computer, iPad, smart phone, or compatible device.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: 1 [2]  All   Go Down
  Print  
Author Topic: Looking for a Source of Panel Switches  (Read 2978 times)
gumpy
Some Assembly Required
Hero Member
*****
Offline Offline

Posts: 4083


Slightly modified 1982 MC9


WWW

Ignore
« Reply #15 on: November 14, 2007, 05:55:47 PM »

RCB,

What switches are you talking about. A SPST with 1 light is only 3.87.

The switches are very simple. You can open them up and probably fix the one that didn't work. It's probably just misaligned inside.

Also, it's not real difficult to install LEDs inside them. You can remove the bulbs that are burned out, and replace them with a 1/4 watt resistor and led. Takes a bit of finess to solder it in, but it's not too difficult. I did it on a couple dozen that I'll be using on my electrical relay system.

I might be persuaded to modify them for you if you want to send them out. Cost plus. I'm very reasonable. I like dark beer.  Roll Eyes

craig


Logged

Craig Shepard
Located in Minnesquito

http://bus.gumpydog.com - "Some Assembly Required"
Pages: 1 [2]  All   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!