Bus Conversions dot Com Bulletin Board
November 28, 2015, 05:16:10 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: It will not be stolen by your mailman or your neighbor who also may be into buses.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: vip smartwheel help  (Read 1291 times)
Full Member
Offline Offline

Posts: 164

« on: May 27, 2006, 08:38:35 PM »

I had purchased a smartwheel with the column, clockspring and master control module. Does anyone have any experiences installing one/ Looking for wiring diagram, contacts for parts & service at vip etc. Thanks ray
Hero Member
Offline Offline

Posts: 7403

« Reply #1 on: May 27, 2006, 10:08:44 PM »

Typically, smart wheels use two or three contacts on the wheel that leads to a multiplexing unit.  The switches have their own "tone" (like a telephone).  When you push one of the buttons on the steering wheel, the switch transmits its' distinct frequency to the multiplexing unit that figures out which frequency it is and directs it to whatever needs to turn on.  Without the multiplexing unit, the smartwheel will just be a dumb wheel with a bunch of switches on it.  Good Luck, TomC

Tom & Donna Christman. '77 AMGeneral 10240B; 8V-71TATAIC V730.
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!