Bus Conversions dot Com Bulletin Board
October 09, 2015, 02:27:23 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: You will not have to go out in the rain, sleet, hail, or snow to retrieve it.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: [1]   Go Down
Author Topic: anybody know where the coolant temp sensor is on a 8.2L detroit?  (Read 1299 times)
Offline Offline

Posts: 45


« on: May 28, 2006, 01:03:58 PM »

I believe that my sender is bad on this engine. The gauge is pegged, and stays on the low end at all times.

On a detroit diesel 8.2L fuel pincher, where would the temp sensor be in a transit configuation? My books dont show it.




Proud single custodial dad to a wonderful 14 year old son, Owner of a 1986 Neoplan 26' transit Bus AN408, Great weekender...Lots of work to come on this bus, can't wait to get her done! 8.2L with a Allison AT545...
Hero Member
Offline Offline

Posts: 523

« Reply #1 on: May 28, 2006, 01:14:22 PM »

It's been a real long time since i wrenched on one of those, but try the basic locations.
I'd look around by the thermostat housing, or possibly mounted into one of the cylinder heads.
Usually would thread into either location.
Good luck.  Cool
Pages: [1]   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!