Bus Conversions dot Com Bulletin Board
November 26, 2015, 09:30:27 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: If you had an Online Subscription: It will not get torn up or crushed if you back over it with your bus.
   Home   Help Forum Rules Search Calendar Login Register BCM Home Page Contact BCM  
Pages: 1 [2]  All   Go Down
Author Topic: What should I do here?  (Read 2919 times)
Hero Member
Offline Offline

Posts: 2553

'85 Neoplan Spaceliner "Odyssey"


« Reply #15 on: May 01, 2008, 03:16:14 PM »


I will say it again:  You will have overheating problems if you don't seal this door.

The opening is there for engine access.  You need to seal it with something removable.  Hinges are fine, but not necessary.

I have such a door in my bus -- it comes out completely for maintenance.


Full-timing in a 1985 Neoplan Spaceliner since 2004.
Our blog: http://OurOdyssey.BlogSpot.com

« Reply #16 on: May 02, 2008, 06:30:02 AM »

As most of the above have posted is correct.

Bob….your answer is to put a metal (no holes or screen) door to block off engine’s heat from engine compartment to avoid heated air getting into front of radiator. The outside door is screened or louver or slotted to allow cool fresh air into radiator.

The bottom-line is to achieve the coolest air for both radiator and engine’s air intake to air cleaner. Make sure all isolation joints are sealed with approved sealant and opening is blocked.


Sojourn for Christ, Jerry
Pages: 1 [2]  All   Go Up
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!