- Welcome to BCM Community.
Recent posts
#61
Bus Topics ( click here for quick start! ) / Re: Good Sam's
Last post by Gary Hatt - Publisher BCM - August 08, 2026, 09:42:05 PMI had Bad Sams for about 3 years, when I got my first bus, and called them maybe 3 times on 2 different vehicles. They always sent the wrong equipment for the job, and it took them several hours to show up each time.
I switched to Coach-Net a couple of years ago. I heard they are better with big buses, but thankfully, I haven't had to use them yet.
I switched to Coach-Net a couple of years ago. I heard they are better with big buses, but thankfully, I haven't had to use them yet.
#62
Bus Topics ( click here for quick start! ) / Good Sam's
Last post by luvrbus - August 08, 2026, 03:10:02 PMIf any of you guys have Good Sam's towing insurance they have dropped towing a converted bus from any type commercial bus, I have 2 friends that were dropped and fighting Good Sam's for the return of there money with no luck.I figured it was going to happen since most tow insurance restricts the mileage and to closest repair center and no one will work on a vehicle over 10 years old now except a private owned shop and that doesn't aways work out great for a owner ,If you have Good Sam's you need to check before you pay or need it
#63
Bus Topics ( click here for quick start! ) / Re: Hydrogen retro fit and sem...
Last post by lvmci - August 06, 2026, 09:17:25 PMClean Energy Wins $27.5M OCTA Hydrogen Contract
by ESG News Editorial Team • August 6, 2026
Clean Energy Fuels will design and build a private hydrogen station for Orange County Transportation Authority under a $27.5 million contract.
The facility will support OCTA's expanding hydrogen bus fleet and is scheduled for completion in 2028.
OCTA plans to operate a fully zero-emission bus fleet by 2040, in line with California's clean transit regulations.
Clean Energy Fuels has secured a $27.5 million contract to build a hydrogen fueling station for one of Southern California's largest public transport agencies.
The Orange County Transportation Authority awarded the contract for a private station at its Garden Grove bus base. The facility will support OCTA's expanding fleet of hydrogen fuel cell buses...
by ESG News Editorial Team • August 6, 2026
Clean Energy Fuels will design and build a private hydrogen station for Orange County Transportation Authority under a $27.5 million contract.
The facility will support OCTA's expanding hydrogen bus fleet and is scheduled for completion in 2028.
OCTA plans to operate a fully zero-emission bus fleet by 2040, in line with California's clean transit regulations.
Clean Energy Fuels has secured a $27.5 million contract to build a hydrogen fueling station for one of Southern California's largest public transport agencies.
The Orange County Transportation Authority awarded the contract for a private station at its Garden Grove bus base. The facility will support OCTA's expanding fleet of hydrogen fuel cell buses...
#64
Bus Topics ( click here for quick start! ) / This beautiful 1981 Eagle Bus ...
Last post by Gary Hatt - Publisher BCM - July 29, 2026, 06:06:19 PMTo view this bus, click on the link below:
https://www.busconversions.com/bus_classifieds/
If you have a bus to sell, we can help you list it on our website for just $99.00 until it sells.
To list your bus for sale, simply click on this link and fill out the online form: https://www.busconversions.com/bcmclassifieds/ or email Gary@BusConversionMagazine.com with your classified info, or call the office at the phone number at the bottom of our website.
Please note: We post these notes as a service to our readers and paid advertisers that support this Forum, which is solely supported by subscriptions and display advertisers, as well as Classified ads.
This Forum does not allow individual posting of buses for sale.
https://www.busconversions.com/bus_classifieds/
If you have a bus to sell, we can help you list it on our website for just $99.00 until it sells.
To list your bus for sale, simply click on this link and fill out the online form: https://www.busconversions.com/bcmclassifieds/ or email Gary@BusConversionMagazine.com with your classified info, or call the office at the phone number at the bottom of our website.
Please note: We post these notes as a service to our readers and paid advertisers that support this Forum, which is solely supported by subscriptions and display advertisers, as well as Classified ads.
This Forum does not allow individual posting of buses for sale.
#65
Bus Topics ( click here for quick start! ) / Re: Air compressor wonkiness. ...
Last post by plyonsMC9 - July 29, 2026, 04:35:02 PMThank you Clifford!, Phil
#66
Bus Topics ( click here for quick start! ) / Re: 110 and 12v locations on t...
Last post by Jim Blackwood - July 29, 2026, 12:46:51 PMThanks, maybe they do. I'll get into it more later. Might be just one row came on another way. Might have been when I had the bus running. I've been turning on those lights by plugging a short extension cord into my inside outlets and running it out the side window to plug into the panel but I'm sure there's a better way to do that.
I'll check out that terminal 55, just need to go through the bulkhead and power the bed lift struts. That gets me started on the 12v wiring and there's several things to do there.
Jim
I'll check out that terminal 55, just need to go through the bulkhead and power the bed lift struts. That gets me started on the 12v wiring and there's several things to do there.
Jim
#67
Bus Topics ( click here for quick start! ) / Re: 110 and 12v locations on t...
Last post by luvrbus - July 29, 2026, 07:42:17 AMI forget but I think terminal 55 in the rear JB is the only 12v supply in the engine compartment besides the alternator exciter field you can pickup a 12v supply from the Vanner or the cut off switch on the DL3.Both rows of lights should come on when you plug into station lighting,I don't what is going on there
#68
Bus Topics ( click here for quick start! ) / 110 and 12v locations on the 1...
Last post by Jim Blackwood - July 29, 2026, 06:50:04 AMI have two immediate inquiries.
The first one is two parts. 1) where is a good source for 12vdc power in the engine compartment? and 2nd where can you get 12v power inside the coach? Are there other possibilities than the panel under the driver's window? I still have the overhead bins and associated wiring. Also, I have some wires sticking out of the ceiling that I think might have been courtesy lights or maybe a switch where the bathroom was.
The second inquiry has to do with the florescent interior lighting. This would be 110v right? OK, I know if you plug in a cord to the socket below the driver's side panel on the outside of the bus one row of the lights comes on and there are two rows but I don't want to make this two complicated right away.
Is there an easy way to wire in shore power and a switch or two so that the florescent lights can be switched on from shore power other than running wires to the extension cord socket on the side of the bus? I already have a shore line, breaker panel, and 110v wiring for outlets run inside the bus. Any ideas here? I'd like to make it as convenient as I can. Might consider a 3 way circuit with one switch by the door and one in the bedroom.
Jim
The first one is two parts. 1) where is a good source for 12vdc power in the engine compartment? and 2nd where can you get 12v power inside the coach? Are there other possibilities than the panel under the driver's window? I still have the overhead bins and associated wiring. Also, I have some wires sticking out of the ceiling that I think might have been courtesy lights or maybe a switch where the bathroom was.
The second inquiry has to do with the florescent interior lighting. This would be 110v right? OK, I know if you plug in a cord to the socket below the driver's side panel on the outside of the bus one row of the lights comes on and there are two rows but I don't want to make this two complicated right away.
Is there an easy way to wire in shore power and a switch or two so that the florescent lights can be switched on from shore power other than running wires to the extension cord socket on the side of the bus? I already have a shore line, breaker panel, and 110v wiring for outlets run inside the bus. Any ideas here? I'd like to make it as convenient as I can. Might consider a 3 way circuit with one switch by the door and one in the bedroom.
Jim
#69
Bus Topics ( click here for quick start! ) / Re: Air compressor wonkiness. ...
Last post by luvrbus - July 29, 2026, 05:39:14 AMYou can try changing the governor on the compressor (20 bucks) that is a easy job on the road,that is only 1/2 of the puzzle the governors controls the unloader valves inside the older compressors. that is more of a job you need to drain the cooling system and remove the compressor head to change those,I never change a governor without changing the unloader valves I keep a case in the shop,Give the governor change a shot 1st you could get lucky and it is easy, a broke control line from the governor to the dryer can cause one to over build PSI too
#70
Bus Topics ( click here for quick start! ) / Re: Which dashcam are you usin...
Last post by Iceni John - July 28, 2026, 10:51:18 PMThanks for the suggestions. It's a pity that dashcam makers don't list the minimum and maximum windshield angles that their cams can work on. In the meanwhile I have to install the Viofo in my car without damaging the headliner or A-pillar trim!